199002962 - D015 POOR CHANGE IN ENGINE SPEED ON PRESSING ACCELERATOR PEDAL

The customer complains that: Reduced adjustment speed
Test results
1MODE PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:- Battery voltage    See Test 5530BB BATTERY VOLTAGE CHECK- Accelerator position 1 AD/C- Accelerator 2 position AD/C    See Test 1068AC ACCELERATOR PEDAL CHECKS- Coolant temperature    See Test 1060OE ENGINE COOLANT TEMPERATURE SENSOR OPERATION CHECK- Diesel temperature    See Test 1060EA DIESEL TEMPERATURE CHECKMove on to Step 2
2INTAKE AND SUPPLY CIRCUITS CHECKAll OKProblems encounteredOperation
Check that the air intake/vacuum circuit is working properly    See Test 1048OA AIR INTAKE/VACUUM CIRCUIT CHECKCheck the condition of the fuel supply circuit and make sure that it is working properly    See Test 1040OA FUEL SUPPLY CIRCUIT CHECKMove on to Step 3
3CONFIGURATION TESTSAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check in the Configurations section whether the replacement of any of the following components is followed by their subsequent configuration:- injectorIn this case, carry out the configuration, checking that the outcome is positiveMove on to Step 6The outcome of the configuration is not positiveMove on to Step 4
4ERROR CHECKAll OKProblems encounteredOperation
Check whether any of the following errors are present using the diagnostic equipment:- P1301- U0001- U0426- U1700Move on to Step 61. Error P1301 is present2. Error U0001 is present3. Error U0426 is present4. Error U1700 is present1. Move on to Step 52. Continue as indicated    See table U0001 CAN line error3. Memorise the CODE. If it is not possible, replace the engine control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R 4. Continue as indicated    See table U1700 CAN network (NCM - NBC)
5IMA CLASSIFICATIONAll OKProblems encounteredOperation
In the Configurations section on the diagnostic tester, rerun the IMA classification and ensure it is successfulEnd of diagnosisThe classification is unsuccessfulReplace the engine management control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R
6MODE PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:- Measured Diesel pressure    See Test 1060GH DIESEL PRESSURE CHECK- Pressure regulator opening (MPROP)    See Test 1060GR CHECK OPERATION OF FUEL PRESSURE SENSOR ON RAIL- Engine rpm    See Test 1060GI CHECK ENGINE SPEEDEnd of diagnosis