199002963 - D016 POOR ENGINE RESPONSE

The customer complains that: Poor engine response
Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameter:- Battery voltage    See Test 5530BB BATTERY VOLTAGE CHECKMove on to Step 1
1CONFIGURATION TESTSAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check in the Configurations section whether the replacement of any of the following components is followed by their subsequent configuration:- injectorIn this case, carry out the configuration, checking that the outcome is positiveMove on to Step 4The outcome of the configuration is not positiveMove on to Step 2
2ERROR CHECKAll OKProblems encounteredOperation
Check whether any of the following errors are present using the diagnostic equipment:- P1301- U0001- U0426- U1700Move on to Step 41. Error P1301 is present2. Error U0001 is present3. Error U0426 is present4. Error U1700 is present1. Move on to Step 32. Continue as indicated    See table U0001 CAN line error3. Memorise the CODE. If it is not possible, replace the engine control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R 4. Continue as indicated    See table U1700 CAN network (NCM - NBC)
3IMA CLASSIFICATIONAll OKProblems encounteredOperation
In the Configurations section on the diagnostic tester, rerun the IMA classification and ensure it is successfulEnd of diagnosisThe classification is unsuccessfulReplace the engine management control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R
4POWER SUPPLY CIRCUIT CHECKAll OKProblems encounteredOperation
Check the condition of the fuel supply circuit and make sure that it is working properly    See Test 1040OA FUEL SUPPLY CIRCUIT CHECKMove on to Step 5
5MODE PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:- Coolant temperature    See Test 1060OE ENGINE COOLANT TEMPERATURE SENSOR OPERATION CHECK- Diesel temperature    See Test 1060EA DIESEL TEMPERATURE CHECK- Air temperature (debimeter)    See Test 1060GK CHECK CONTROL UNIT SOFTWARE AND HARDWARE. Atmospheric pressure    See Test 1060GD ATMOSPHERIC PRESSURE CHECKMove on to Step 5
6INTAKE CIRCUIT CHECKAll OKProblems encounteredOperation
Check that the air intake/vacuum circuit is working properly    See Test 1048OA AIR INTAKE/VACUUM CIRCUIT CHECKMove on to Step 7
7MODE PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:- Accelerator position 1 AD/C- Accelerator position 2 AD/C    See Test 1068AC ACCELERATOR PEDAL CHECKS- Measured Diesel pressure    See Test 1060GH DIESEL PRESSURE CHECK- Pressure regulator opening (MPROP)    See Test 1060GR CHECK OPERATION OF FUEL PRESSURE SENSOR ON RAILEnd of diagnosis